![]() But if you need to use it anyway, here's some diagnostics. ![]() To use xterms, you must run the X11 server component of Cygwin, also known as Cygwin-X.Īpparently you're using the traditional X11 connection procedure, which results in an unencrypted X11 connection: anyone on the same network can spy on your keyboard and mouse actions. This is kind of similar to Windows Command Prompt: it cannot display any graphics. In the attached picture is a cygwin terminal window. Minimum = 29ms, Maximum = 31ms, Average = 30msĪnd also I can ping my PC from the HPUX server. Packets: Sent = 2, Received = 2, Lost = 0 (0% loss),Īpproximate round trip times in milli-seconds: ![]() Reply from HPUX : bytes=32 time=31ms TTL=251 Reply from HPUX : bytes=32 time=29ms TTL=251 I have disabled my windows firewall and other firewalls. Xterm Xt error: Can't open display 192.165.15.3 #xhost + 192.165.15.3-> This is the IP address of my Windows PC I have enabled the first line to 1 in /etc/rc.config.d/xfs #export DISPLAY=192.165.15.3:0.0 -> This is the IP address of my Windows PC Now I login to my HPUX box through putty and give the following :: Attached is the screenshot of what I get when I open cygwin. I have installed Cygwin on my Windows Vsta PC. I have checked out google and also the previous posts in this forum, however was not very clear enough.
0 Comments
Leave a Reply. |